Ge-industrial-solutions AF-600 FP OPCMBTCP Modbus TCP Option Manual de usuario descargar pdf (Pagina 9)

3.1.2 How to Install Option in Frequency Converter

Items required for installing a network option in the frequency converter:

- The network option

- Network option adaptor frame for the AF-650 GP/AF-600 FP. This frame is deeper than the standard frame, to allow space for the network option beneath

- Strain relief (only for unit size 12)

Instructions:

- Remove Keypad panel from the AF-650 GP/AF-600 FP.

- Remove the frame located beneath and discard it.

- Push the option into place. The Ethernet connectors must be facing upwards.

- Remove both knock-outs on the network option adaptor frame.

- Push the network option adaptor frame for the AF-650 GP/AF-600 FP into place.

- Replace the Keypad and attach cable

NB!

Do not strip the Ethernet cable and ground it via the strain relief-plate! The grounding of screened Ethernet cable is done through the RJ-45 connector on the

option.

NB!

After installing the OPCMBTCP option, be aware of the following parameter settings:

par. O-01 Control Site: [2] Controlword only or [0] Digital and ctrl. word

par. O-02 Control Word Source: [3] Option A

Modbus TCP

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 53 54

Comentarios a estos manuales

Sin comentarios

Ge-industrial-solutions AF-600 FP OPCMBTCP Modbus TCP Option Manual de usuario Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Equipo Ge-industrial-solutions AF-600 FP OPCMBTCP Modbus TCP Option